| Author | Post |
|---|
made in canada
Member
|
Posted: Wed Jul 1st, 2009 02:07 pm |
|
I think it came out good for a days work.
____________________
95 zj---> under the knife
|
93grand
Member
|
Posted: Wed Jul 1st, 2009 02:10 pm |
|
what did you use for steel? nice looking bumper
____________________
93 Jeep Grand,4.0L,4'' lift,31
Remember: Everyone seems normal until you get to know them
|
made in canada
Member
|
Posted: Wed Jul 1st, 2009 02:20 pm |
|
the main part going across is 6" channel, then i built the frame for the sides with 1x2" stock, plated it in with sheet metal i had around the building (14g ish).
the best part was i could not get the bumper off the jeep because clearances where so tight, so i had to weld the whole think on jeep, and all done with a stick.
____________________
95 zj---> under the knife
|
rebel3.0
Member
|
Posted: Wed Jul 1st, 2009 02:39 pm |
|
| looks good and strong
____________________
98 4x4 3.slow 5 speed. 3inch Performance Accessories body lift,T-bar crank, "custom" Wyman industries light tabs,KC daylighters. K&N drop in filter.33x12.5 BF allterrains etc nothin special.
|
blaze
Member
|
Posted: Thu Jul 2nd, 2009 12:13 am |
|
| looks pretty sweet
____________________
'91 Sonoma, 3" body lift, 2" shackles/t-bar crank, 32x11.5 mud terrains
|
Gonecountry
Member
|
Posted: Sat Jul 4th, 2009 03:06 am |
|
| Nice Fab job
____________________
1996 Ford F150 302cid, 31x10.5/15's
|
Current time is 03:19 pm | |
|